The measure visit for a new floor in Virginia
Every 2H Flooring LLC job starts with a measure visit at your home. It is where the plan is made, and it is the reason install day runs smoothly. We come with a tape, a straightedge and samples, walk every room on the list and write down what we find.

Five parts of the visit
We walk the rooms
We start where you want the new floor and follow the path from room to room: entry, hall, living areas, bedrooms and closets. Doorways, stair edges and floor registers all get a note.
We measure each space
Every room is measured wall to wall, closets included. L-shaped rooms and rooms with bays or alcoves are broken into simple parts so nothing is missed when the material is ordered.
We check the base
A long straightedge shows dips and humps. Where we can, we lift a corner of the carpet or look at a floor register to see what lies under the current covering.
We talk through materials
With samples on the floor in your own light, we compare vinyl plank, laminate, hardwood and carpet for each room and how it is used.
You get it in writing
The rooms, the material, the prep, the trim and the steps go into a written estimate. You decide in your own time.
How we measure different room shapes
Most rooms fall into one of three shapes. Try them in the room calculator on the home page.
Square and rectangular rooms
The simplest case. We measure both directions, note the window wall and plan the rows so the last one is not a thin sliver at the far wall.
L-shaped rooms
An L is measured as two rectangles. Planks usually run the same direction through both legs, so the floor reads as one space, and we plan the corner where the rows meet.
Rooms with a closet
Closets get the same floor as the room, laid in the same direction. The closet doorway is often the tightest cut in the room, so we look at it closely.
Heights and edges we check
A new floor changes the height of the surface by a little. These are the places where that small change matters.
- The finished floor height at every door, so doors still swing clear
- The height at the dishwasher and range openings in a kitchen
- Stair nosing where a new floor meets the top or bottom step
- Floor registers that need a clean cut around them
- Transitions to rooms that are keeping their current floor
- Where furniture will go during the install
Why we lift a corner
What sits under the current floor changes the prep more than anything else. Carpet may hide original oak, a plywood subfloor or a patched area from an older project. Sheet vinyl may be glued to a flat underlayment or sit over a second layer. Each case calls for a different amount of preparation, and seeing it at the visit means the written estimate matches the real work.
What the written estimate covers
The estimate lists each room by name, the floor chosen for it, the removal of the old covering, the base preparation, the underlayment, the trim and the transitions. It also notes anything you will want to handle before the day, such as emptying closets or taking down items near the floor. If you change your mind about a room later, we update the estimate before the install date is set.
Questions about the measure visit
How long does a measure visit take?
A single room takes a short visit. A whole level with several rooms, stairs and closets takes longer. We let you know roughly how long when we book.
Do I need to be home?
Yes, ideally. The visit is also the time to talk through the rooms and materials, and it helps to hear how the space is used.
Can you measure from a floor plan?
A plan is a helpful start, but we always measure in person. Walls are rarely perfectly square, and the base under the floor only shows up on site.
What should I have ready?
Clear access to each room and closet, and any samples or photos of floors you like. Pets in another room make the visit easier for everyone.
Book your measure visit
Tell us which rooms you have in mind. We reply during office hours to set up a measure visit and put the plan in writing.